Avaya Definity SI, Руководство по обслуживанию, Страница: 1570 / 2968

Maintenance Object Repair Procedures
555-233-123 10-784 Issue 4 May 2002
Expansion Interface Local Loop Around Test
(#240)
This test is similar to the Lightwave Transceiver Loop Around Test described in
Test #242. A test tone from TDM Bus A is received by the Expansion Interface
circuit pack under test, but is not transmitted out to the lightwave transceiver
before being looped back onto TDM Bus A again. The test is then repeated using
TDM Bus B. Thus, this loopback test is performed on each TDM Bus on the
network containing the Expansion Interface circuit pack to verify that the
Expansion Interface circuit pack is able to loopback data on each TDM Bus. Since
this loopback is internal to the circuit pack, this test does not interfere with the
normal fiber data stream.
0 NO
BOARD No board was detected by the test.
1. Check the error log for wrong board (error 125) or no
board (error 131). Resolve either of these issues, if
applicable.
2. Check that the board is properly translated and inserted. If
so, check for hyperactivity (error 1538). If hyperactive, use
the reset board PCSS command.
3. Run the test again. If it fails, the ID chip on board may be
bad. Replace the board and retest.
Table 10-291. TEST #240 EI Local Loop Around Test
Error
Code Test
Result Description/Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5
times.
Continued on next page
Table 10-290. TEST #238 EI Fiber Out-of-Frame Query Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page