Avaya Definity SI, Руководство по обслуживанию, Страница: 166 / 2968

Routine Maintenance Procedures
555-233-123 5-62 Issue 4 May 2002
11. Terminate the test by entering test ds1-loop <location> end
cpe-loopback-jack-test. Wait about 30 seconds for the DS1 to re-frame
on the incoming signal and clear DS1 facility alarms.
Loopback termination fails under the following conditions:
a. The span is still looped somewhere. This could be at the loopback
jack, at the ICSU, or somewhere in the network. This state is
indicated by a fail code of 1313. If the red LED on the loopback jack
is on, replace the ICSU. Re-run the test and verify that the loopback
test terminates properly. If not, replace the DS1 circuit pack and
repeat the test.
b. The DS1 cannot frame on the incoming span’s signal after the
loopback jack is powered down. This means that there is something
wrong with the receive signal into the loopback jack from the “dumb”
block or the Smart Jack. If the service provider successfully looped
and tested the span, up to the Smart Jack, this condition isolates the
problem to the wiring between the loopback jack and the Smart
Jack. Refer to “Loopback Jack Fault Isolation Procedures” for
information on how to proceed in this case. The test cannot be
successfully terminated until a good signal is received. To properly
terminate the test before a good receive signal is available, enter
reset board <location>.
12. Restore the “TX LBO” field to the original value recorded in Step 2.
13. Release the DS1 circuit pack using the release board UUCCSSpp
command.
14. Leave the loopback jack connected to the DS1 span.
Loopback Jack Fault Isolation Procedures
This section describes the possible DS1 configurations in which the loopback jack
may be used. These configurations are: when the DS1 provider includes a Smart
Jack, when no Smart Jack is provided at all, and when sites use fiber multiplexers.
These configurations are separated into “Configurations Using a Smart Jack” and
“Configurations Without a Smart Jack.”