Avaya Definity SI, Руководство по обслуживанию, Страница: 2768 / 2968

Maintenance Object Repair Procedures
555-233-123 10-1982 Issue 4 May 2002
VC Port Reset DSP Test (#1106)
This test is destructive.
This test resets the VC-DSPPT and the DSP associated with it. As part of the
reset procedure, the VC-DSPPT will execute a series of self- tests on the
hardware. If these self- tests fail, the test will fail; otherwise the test will pass.
Before executing the test, the VC-DSPPT must be busied out by executing the
busy port PCSSpp command. After the completion of the test, the VC-DSPPT
must be released by executing the release port PCSSpp command.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Rerun the test at 1-minute intervals a maximum of 5 times.
0, 1 FAIL The VC-DSPPT DSP Loopback Test failed.
1. Replace the circuit pack.
PASS The VC DSPPT DSP Loopback Test passed
Table 10-712. TEST #1106 VC Port Reset DSP Test
Error
Code Test
Result Description/Recommendation
1000 ABORT System resources required to run this test are not available, or the
port may be busy with a call.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1015 ABORT The VC-DSPPT is not busied out.
1. Busy out the VC-DSPPT by executing the busy port PCSSpp
command and then retry the test.
2000 ABORT Response to the test was not received from the VC-DSPPT within
the allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If this result occurs again, replace the circuit pack.
Continued on next page
Table 10-711. TEST #1105 VC-DSP Port DSP Loopback Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page