Avaya Definity SI, Руководство по обслуживанию, Страница: 2411 / 2968

TAPE (Tape Unit) [G3iV1.1-286]
Issue 4 May 2002 10-1625 555-233-123
Tape Translation Status Test (#505)
This test checks whether the TAPE is currently alarmed due to the failure of a load
translation or save translation attempt on the TAPE.
Table 10-601. TEST #505 Tape Save Translation Status Test
Error
Code Test
Result Description/Recommendation
1029 to
1030
and
2011,
2013
to
2051 ABORT Refer to the STBY-SPE (Standby SPE) Maintenance
documentation for a description of these error codes.
2012 ABORT 1. Do the steps below following the directions in the ‘‘Tape
Maintenance and Repair Procedures’’ section.
2. Issue the test tape long command. If the test passes,
issue the save translations command to verify condition
is clear.
3. If the test fails, make sure tape is fully inserted.
4. If the test continues to fail, clean the tape head and
retest.
5. If fail, swap tape and retest.
6. If the test still fails, swap tape unit, use original tape and
retest.
FAIL The tape is currently alarmed because a save translation or a
load translation attempt failed on this tape. Look for Errors
Types #3329, #3841, #3842, and #3843 in the Hardware
Error Log and resolve these errors by following the
procedures provided in the “Hardware Error Log Entries and
Test to Clear Values” section.
PASS The last load translation and (if any) save translation attempts
were successful on this tape.
Continued on next page