Avaya Definity SI, Руководство по обслуживанию, Страница: 1029 / 2968

ATM-TRK (Circuit Emulation Service Circuit Pack)
Issue 4 May 2002 10-243 555-233-123
Packet Interface Loop Around Test (#598)
This nondestructive test checks the ATM-TRK circuit pack’s packet-bus interface.
The LANHO chip sends data through the bus and back to itself.
Table 10-151
describes this test, substituting “CES mode” for “PNC mode.”
If the data received is consistent with the data sent, the test passes. The test does
not run if the packet bus in the specified port network has a minor alarm, or is out
of service, or if the packet bus in the PPN is out of service.
Table 10-96. Control Channel Test #52
Error
Code Test
Result Description/Recommendation
2000 ABORT Test request timed out.
2100 ABORT Could not allocate needed system resources.
2500 ABORT Internal system error
Retry the command up to 3 times at 1-minute intervals.
FAIL The ATM circuit pack responded incorrectly.
Retry the command up to 3 times at 1-minute intervals.
If the test continues to fail, reset the ATM-TRK circuit pack (reset
board UUCSS).
If test continues to fail, replace the circuit pack or transceiver.
PASS The ATM-TRK circuit pack is communicating correctly with the
software.
0 NO
BOARD Circuit pack not detected.
Check the error log for Error 125 (wrong board) or Error 131 (no
board), and correct any errors found.
Make sure that the ATM-TRK circuit pack is properly translated
and inserted.
Check for Error 1538 (hyperactivity). If hyperactive, run reset
board UUCSS.
Run the test again. If it fails, replace the ATM-TRK circuit pack,
and retest.
Continued on next page