Avaya Definity SI, Руководство по обслуживанию, Страница: 1923 / 2968

M/T-ANL (Maintenance/Test Analog Port)
Issue 4 May 2002 10-1137 555-233-123
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may have
time slots out of service due to TDM-BUS errors. Refer to
TDM-BUS Maintenance documentation to diagnose any
active TDM-BUS errors. A system is considered under heavy
traffic when the Call Processing Occupancy is greater than
50% or when the System Management and the Call
Processing Occupancies together exceed 65%. To view the
system occupancy measurements enter the command status
system health on the system technician terminal.
1. If system has no TDM-BUS errors and is not handling
heavy traffic, repeat test at 1-minute intervals a maximum
of 3 times.
2. If the test continues to abort, escalate the problem.
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of tone detectors
present or some tone detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to TTR-LEV Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer
to TONE-PT Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute
intervals a maximum of 3 times.
1004 ABORT The port has been seized by a valid ATMS test call.
1. Retry the command at 1-minute intervals a maximum of 3
times.
2. If the test continues to abort and the port is not in use on a
valid ATMS Test Call, escalate the problem. To determine
whether the port is in use by an ATMS Test Call enter
status station ext where ext is the assigned ATMS
station number.
2000 ABORT Response to the test request was not received within the
allowable time period.
1. Retry the command at 1-minute intervals a maximum of 3
times.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 3
times.
Table 10-428. TEST #9 NPE Cross Talk Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page