Avaya Definity SI, Руководство по обслуживанию, Страница: 2224 / 2968

Maintenance Object Repair Procedures
555-233-123 10-1438 Issue 4 May 2002
Station Status and Translation Audits and
Updates Test (#36)
This test updates the analog port’s message lamp state (if it has one) and
translations with information in the software.
Table 10-545. TEST #36 Station Status and Translation Audits and Updates
Error
Code Test
Result
Description/Recommendation
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
1004 ABORT The port was seized by a valid call during the test, and the test
was aborted. Use the display port UUCSSpp command to
determine the station extension. Use the status station
command to determine the service state of the port. If the port is
in use, wait until port is idle.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test
may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the modem
pool member or Music On Hold).
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
1 FAIL This does not indicate a hardware problem. The switchhook
audit failed. The other updates were not performed because of
this failure. This may occur when the audit is performed at the
same time the terminal equipment goes off-hook. Use the
status station command to determine when the port is
available.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
Continued on next page