Avaya Definity SI, Руководство по обслуживанию, Страница: 2091 / 2968

PKT-INT (Packet Interface)
Issue 4 May 2002 10-1305 555-233-123
1537 FAIL The Boot PROM memory checksum test failed. The Packet
Interface may still be operational.
1. Retry the command.
2. If the same error code occurs
a. If the system is not equipped with the High Reliability or
Critical Reliability Configuration replace the
TN2401/TN794 NetPkt at a time that would cause the
least disruption of service. The Packet Interface is still
functional but should be replaced since it may not operate
after a system reboot and it will enter a fatal fault state if it
is reset for other reasons.
b. If the system is equipped with the High Reliability or
Critical Reliability Configuration and if the Packet Interface
is on the standby SPE, replace the standby
TN2401/TN794 NetPkt circuit pack.
c. If the system is equipped with the High Reliability or
Critical Reliability Configuration and if the Packet Interface
is on the active SPE, perform a planned SPE interchange
by entering the command reset system interchange.
Use the status syst 1command to determine that the
standby SPE is in standby mode, and retry the test
command. If the test of the Packet Interface on the
standby SPE continues to fail, replace the standby
TN2401/TN794 NetPkt circuit pack.
Table 10-484. TEST #884 Memory Checksum Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page