Avaya Definity SI, Руководство по обслуживанию, Страница: 857 / 2968

ANL-16-L (16-Port Neon Analog Line)
Issue 4 May 2002 10-71 555-233-123
Any FAIL The NPE of the tested port did not conference the tones
correctly. This will cause noisy and unreliable connections.
1. Issue the display port and the status station
commands to determine if the station is idle. If the station
is found to be idle, issue the test port command for this
port.
2. If the test continues to fail, issue the busyout port and
the release port commands, and then retest the port.
3. If the test still fails, replace the board.
PASS The port can correctly conference multiple connections.
User-reported troubles on this port should be investigated by
using other port tests and by examining station, trunk, or
external wiring.
0 NO
BOARD The test could not relate the internal ID to the port (no board).
This could be due to incorrect translations, no board is
inserted, an incorrect board is inserted, or an insane board is
inserted.
1. Check to ensure that the board translations are correct.
Use the list config command, and resolve any problems
that are found.
2. If the board was found to be correctly inserted in step 1,
issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should
re-establish the linkage between the internal ID and the
port. If this is not the case, dispatch to check to ensure
that there is a valid board inserted.
Table 10-26. TEST #7 Conference Circuit Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page