Avaya Definity SI, Руководство по обслуживанию, Страница: 1956 / 2968

Maintenance Object Repair Procedures
555-233-123 10-1170 Issue 4 May 2002
1004 ABORT The test was aborted because the port was seized by a user for
a valid call. Use status station command to determine the
service state of the port. If the service state indicates that the
port is in use, then the port is unavailable for certain tests. You
must wait until the port is idle before retesting.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort, and the port is not in use,
escalate the problem.
1020 ABORT The test did not run due to an an already existing error on the
specific port or due to a more general error on the circuit pack.
1. Examine the error log for existing errors against this port or
the circuit pack and attempt to diagnose the already existing
error. (Error code 1793 indicates a problem with the DS1
interface board, and any problems on the associated
DS1-BD or UDS1-BD should be resolved first.)
2000 ABORT Response to the test request was not received within the
allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test aborts with error code 2000 again, run short test
sequence on the associated DS1-BD or UDS1-BD. If tests
138 through 145 on the associated DS1-BD or UDS1-BD
are also aborting with error code 2000, hyperactivity on the
board or facility is indicated. In this case, the hyperactivity
problem should be dealt with first.
2100 ABORT System resources required for this test are not available.
1. Retry the command at one-minute intervals a maximum of 5
times.
Table 10-441. TEST #6 NPE Crosstalk Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page