Avaya Definity SI, Руководство по обслуживанию, Страница: 860 / 2968

Maintenance Object Repair Procedures
555-233-123 10-74 Issue 4 May 2002
FAIL The port’s battery feed chip is unable to supply sufficient
power to the terminal equipment. This could be a marginal
test, and the terminal equipment may be operating
satisfactorily.
1. Retry the test at 1-minute intervals for a maximum of 5
times.
2. If the test continues to fail, determine whether the
customer is experiencing problems on this line. Replace
the circuit pack only if the customer is experiencing
problems.
PASS The port’s battery feed chip is able to provide power to the
station equipment to detect on-/off-hook, but may not be able
to supply power for touch-tones. If touch-tones are inoperative
on this station, then replace the circuit pack because this port
is inoperative. User-reported troubles on this port should be
investigated by using other port tests, by examining station
wiring, or by examining the station.
0 NO
BOARD The test could not relate the internal ID to the port (no board).
This could be due to incorrect translations, no board is
inserted, an incorrect board is inserted, or an insane board is
inserted.
1. Check to ensure that the board translations are correct.
Use the list config command, and resolve any problems
that are found.
2. If the board was found to be correctly inserted in step 1,
issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should
re-establish the linkage between the internal ID and the
port. If this is not the case, dispatch to check to ensure
that there is a valid board inserted.
Table 10-27. TEST #35 Battery Feed Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page