Avaya Definity SI, Maintenance Manual, Page: 987 / 2968

ATM-BCH (ATM B-Channel Trunk)
Issue 4 May 2002 10-201 555-233-123
Service State Audit (#256)
This test checks the service state of the trunk.
Country protocol 1. If the interface uses country protocol 1 (includes USA), the
service-state audit executes in all trunk service states. It queries the service state
on the far end and waits 2 minutes for a reply. If the first request times out, the
service-state audit asks again. If the request times out again, it logs error 3073
and resends the request every 15 minutes. It places in-service trunks in the
MAINTENANCE/FAR-END state (outgoing calls blocked, incoming calls
accepted). Incoming calls trigger an immediate service-state audit without waiting
for the end of a 15-minute cycle.
Any other country protocol. If the interface uses some other country protocol, the
service-state audit executes only on trunks that are in the
OUT-OF-SERVICE/FAR-END state. It asks the far-end switch to bring the trunk
back into the IN-SERVICE state and waits 2 minutes for a reply. If the first request
times out, the service-state audit asks again. If the request times out again, it
leaves the trunk in the OUT-OF-SERVICE/FAR-END state and tries again in 1
hour.
NOTE:
PASS for this test only means that a message to the far-end was
successfully sent.
To check the service state of the ATM-BCH trunk, run status trunk grp#/mbr#.
Table 10-70. TEST #256 Service State Audit Test
Error
Code Test
Result Description/Recommendation
1000 ABORT Needed resources not available, port on a call or initializing
1. Run status trunk grp#/mbr#.
1. Check the results of Test #255.
1018 ABORT Maintenance disabled
1. Enable maintenance by entering y in the
Maintenance
Tests?
field on page 2 of the change trunk-group form.
1113 ABORT Signaling link failed
1. Run status trunk grp#/mbr#.
2. Check the results of Test #255.
3. See the ‘‘ATM-SGRP (ATM Signaling Group)’’ maintenance
object.
Continued on next page