Avaya Definity SI, Maintenance Manual, Page: 983 / 2968

ATM-BCH (ATM B-Channel Trunk)
Issue 4 May 2002 10-197 555-233-123
Error Log Entries and Test to Clear Values
Notes:
a. Error Type 1: the two ends of the ATM trunk do not agree on the ISDN call
state. Possible causes:
■
Received a DISConnect or RELease COMplete message with
cause value 52 (outgoing calls barred)
■
Received a DISConnect or RELease COMplete message with
cause value 54 (incoming calls barred)
■
Outgoing call renegotiated by the far end to another B-channel in
the absence of SETUP message glare
■
Near end attempted a call on a B-channel that the far end has
marked OOS
When running the Short Test Sequence, pay close attention to the results
of the Call State Audit Test (#257).
Table 10-67. ATM-BCH Error Log entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1 Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
0 Any Any Any test port UUCSSppp
1( a ) Any None test port UUCSSppp
18 0 busyout trunk grp/mbr release trunk grp/mbr
129 ( b ) None WNG OFF test port UUCSSppp
130 ( c ) test port UUCSSppp
257( d ) Any Service State Audit (Test
#256) test port UUCSSppp
513( e ) Any None WNG OFF test port UUCSSppp
769( f ) Any Service State Audit (Test
#256) test port UUCSSppp
1793( g ) Any None test port UUCSSppp
3073( h ) Any Service State Audit (#256) test port UUCSSppp
3585( i ) Any None none
3841( j ) Any None WNG OFF none
Continued on next page