Maintenance Object Repair Procedures
555-233-123
10-1642
Issue 4 May 2002
System Technician-Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order presented in the table below when inspecting
errors in the system. By clearing error codes associated with the Tape Diagnostic
Test, for example, you may also clear errors generated from other tests in the
testing sequence.
Notes:
a. See TAPE (Tape Unit) Maintenance documentation for this test description.
b. This test does not run in release G3iV1 EDI 7.0 or later.
c. The Tape Consistency Test does not run in a Standard system.
Tape Data Consistency Check Test (#421)
The software vintage number, translation time stamps, announcement time
stamps, and update file time stamps and identifiers are read off both tapes and
compared. If the comparison shows any discrepancy, TAPE-DAT is alarmed. This
test is run in a High or Critical Reliability Option system. The test is run as part of
the test tape long and as part of weekly TAPE maintenance.
Order of Investigation
Short Test
Sequence
Long Test
Sequence
D/ND
1
1
D = Destructive; ND = Nondestructive
Tape Reset Test (#67) (a)
X
ND
Tape DMA Latch Test (#230) (a)
X
X
ND
Tape Diagnostic Test (#66) (a)
X
X
ND
Tape Read/Write Test (#65) (a) (b)
X
ND
Tape Block Error Test (#692) (a) (b)
X
ND
Tape Status Test (#69) (a)
X
X
ND
Tape Translation Status Test (#505) (a)
X
ND
TAPE-DAT Tape Consistency Test (#421) (c)
X
ND
Summary of Contents for Definity SI
