Avaya Definity SI, Maintenance Manual, Page: 884 / 2968

Maintenance Object Repair Procedures
555-233-123 10-98 Issue 4 May 2002
1006 ABORT This port has been busied out by command or taken
out-of-service by the failure of the NPE Crosstalk Test.
1. Look in the Error Log for Error Type 18 (port busied out) for
this port. If this error is present, then release the port with
the release station extension command and run the test
again.
2. Look in the Error Log for Error Type 1025 (NPE Crosstalk
Test failed) for this port. If this error is present, then
investigate the errors associated with the NPE Crosstalk
Test (#6) first.
3. Make sure that the terminal is connected and in service,
and then retest.
ABORT Could not allocate the necessary system resources to run this
test.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1 FAIL This does not indicate a hardware problem. The switchhook
audit failed, and the other updates were not performed
because of this failure. This condition may occur when the
audit is performed at the same time that the terminal
equipment goes off-hook. Use the status station command to
determine when the port is available for testing.
1. When the port becomes available for testing, retry the
command at 1-minute intervals a maximum of 5 times.
5 FAIL This does not indicate a hardware problem but may indicate an
internal software error. The message waiting lamp update
failed. The translation and ringer updates were not performed
because of this failure.
7 FAIL The translation update failed. The ringer update was not
performed because of this failure. This does not indicate a
hardware problem but may be an internal software error.
Table 10-34. TEST #36 Station Status and Translation Audits and Updates Test
— Continued
Error
Code Test
Result Description/Recommendation
Continued on next page