
Maintenance Object Repair Procedures
555-233-123
10-1076
Issue 4 May 2002
IP Address Query Test #1371
This test is destructive.
The Media Processor has two interfaces for configuring the board: through the NT
PC interface, and the SAT via CCMS messages. The SAT via CCMS is the only
approved interface. However, the NT PC interface cannot easily be disabled. It is
possible that changes can be made via the NT PC interface that cause the Media
Processor board to be inconsistent with DEFINITY translation. The area of
concern is the IP address, subnet mask, and gateway translation.
This test sends the Media Processor the IP address, subnet mask, and gateway
translation (IP parameters). If the parameters do not match DEFINITY translation,
the new values are written into the Windows registry, and the NT PC asks the
maintenance sub-system to reboot the board. The board goes through a physical
board removal and insertion.
When this test fails, it is an indication that an illegal change was made and the
customer should be notified. Also, writing the IP address parameters to the
registry requires NT to reboot. If the IP addresses match, there is no need to
update the registry and reboot NT.
Table 10-401.
TEST #1371 IP Address Query Test
Error
Code
Test
Result
Description/Recommendation
ABORT
Internal system error
1. Retry the command at 1-minute intervals a maximum
of 5 times.
2100
ABORT
Insufficient system resources to run this test.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
2801
ABORT
Unable to find IP address data for this location. Verify that the
board is administered.
2807
ABORT
The board is administered, but not enabled in the change
ip-interfaces form.
FAIL
The IP address, subnet mask, and gateway translation
parameters do not match DEFINITY translations. After the new
values are written into the Windows registry, the NT PC must go
through a reboot. The board goes through a physical board
removal and insertion.
1. If the problem persists, replace the circuit pack.
PASS
Translation data matches the Windows Registry.
Continued on next page
Summary of Contents for Definity SI
