TIE-DS1 (DS1 Tie Trunk)
Issue 4 May 2002
10-1739
555-233-123
Notes:
a. Error Type 1—The DS1 Interface circuit pack detects a hardware error on
the DS1 tie trunk. This error can be caused by incompatible translations.
Make sure the parameters administered on the DS1 circuit pack form
match those administered on the far-end switch.
The Aux Data field indicates the following hardware error types:
If all administration errors between the switch and the far-end match, and
these errors continue to recur, follow normal escalation procedures.
b. Error Type 15—This is a software audit error that does not indicate any
hardware malfunction. Run Short Test Sequence and investigate
associated errors (if any).
c. Error Type 18—The DS1 tie trunk has been busied out by a busyout trunk
grp/mbr command. No calls can be made on this trunk except for the
Facility Access Test Call.
d. Error Type 19—This type of error indicates that the far-end may be
out-of-service, or the Electronic Tandem Network may be busied out.
e. Error Type 130—This error type indicates that the circuit pack has been
removed or has been insane for more than 11 minutes. To clear the error,
reinsert or replace the circuit pack.
2562(k)
16665
2817(l)
52992
3840 (m)
Any
Port Audit and
Update (Test #36)
1
Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
2
This alarm will only be raised when the System-Parameter Country form has the Base Tone
Generator field set to 4 (Italy). This alarm will be a MINOR alarm unless 75% or more trunks in this
trunk group are out of service, then the alarm will be upgraded to a MAJOR alarm.
3
Minor alarms on this MO may be downgraded to Warning alarms based on the values used in the
set options command. If the MINOR alarm is not downgraded by the set options values, the
MINOR alarm is upgraded to a MAJOR alarm if 75 percent of the trunks in this trunk group are
alarmed.
57476
On-hook before wink
57477
On-hook before ready to receive digits
57485
Wink too short for valid signal
57487
The timer expired while waiting for an off-hook signal from
the far end as a response at end of digits dialing. Check
the far-end switch for related problems.
DS1 Tie Trunk Maintenance Error Log Entries
Continued on next page
Summary of Contents for Definity SI
