Maintenance Object Repair Procedures
555-233-123
10-216
Issue 4 May 2002
If no other symptoms are present, no action is required. If Layer 3
communication is down:
a. Check for alarms and errors against link components
b. Check out other errors against ATM-SGRP, ATM-TRK, and other
hardware components on the link.
There is no test to clear these errors. The error counter is decremented by
1 every 15 minutes.
b. Error Type 18: the ATM circuit pack has been busied out (either busyout
atm sig-grp or busyout board UUCSS).
1. Release the ATM signaling group (release atm sig-grp) or the
circuit pack (release board UUCSS).
c. Error Type 257: the primary signaling channel connection has been lost for
more than 90 seconds.
■
The associated B-channels are placed in the ISDN
Maintenance/Far-End state.
■
The B-channels are not usable for outgoing calls, although incoming
calls can be accepted.
■
The switch automatically attempts to recover the signaling link.
1. Pay particular attention to the results of Test #636 (Primary
Signaling Link Hardware Check) in the test sequence.
■
When the link does recover, the B-channels are negotiated back to
the In-Service state and their alarms are retired.
2. When this error occurs, the state of the Signaling Group is changed
to out-of-service (verify using the status sig-group command).
d. Error Type 769: signaling link hardware error.
Service-affecting failures of the hardware used to transport the D-Channel
are reported to the ATM CES Signaling Group MO. Maintenance logs this
error, places the D-Channel into the OOS state, and raises a board-level
alarm. The D-Channel is returned to service and the alarm is retired once
the hardware failure condition clears.
e. Error Type 1281: Degraded PVC Alarms indicate that a particular
Permanent Virtual Circuit, or signaling group, has encountered sufficient
errors to exceed firmware thresholds. Operations can continue but at a
lower level of reliability or performance. Firmware filters these alarms so
that only one is reported active at a given time. The following in-line error is
considered a Degraded PVC Alarm:
Summary of Contents for Definity SI
