Avaya Definity SI, Maintenance Manual, Page: 2882 / 2968

Error Messages from Chapter 8: Maintenance
Commands
555-233-123 A-78 Issue 4 May 2002
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
reset maintenance
Help Messages
If the system technician presses
HELP
after entering “reset maintenance” the
following message appears:
Enter cabinet([0]2-[0]3);[carrier(A)]
Error Messages
If the cabinet entered is non numeric or not within a valid range, the following
message appears:
Cabinet number out of range; Enter 2 - 3
If the length of the user entered parameter exceeds three (3), or is in any other
way invalid, the following message appears:
Entry invalid
If the command entered is in conflict with another currently executing command,
then a message displays showing the login ID of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
reset spe-standby
Help Messages
If the system technician presses
HELP
after entering “reset spe-standby” on a
duplex SPE system, the following message appears:
Enter standby SPE recovery level ’1’(WARM), ’2’(COLDII),
’3’(COLDI), ’4’(REBOOT) or ’5’(EXT REBOOT)