Avaya Definity SI, Maintenance Manual, Page: 2940 / 2968

Error Messages from Chapter 8: Maintenance
Commands
555-233-123 A-136 Issue 4 May 2002
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
If the standby is entering maintenance mode when this command is executed,
then the following message appears:
Cannot interrupt Standby SPE while entering
maintenance mode; please try later
If the standby SPE is not refreshed when this command is executed, then the
following message appears:
Standby SPE memory not refreshed;
use the “refresh spe-standby” command.
If the standby SPE is not refreshed and the active SPE is hard selected via the
SPE select switches when this command is executed, then the following message
appears:
Active SPE locked via select switches;
Standby SPE memory not refreshed
If the standby SPE is busy with another task, then the following message appears:
Standby SPE busy with another task;
for information use “status system 1"
If the standby SPE is not available when this command is executed, then the
following message appears:
Standby SPE not available;
for information use “status system 1"
test packet-control
Help Messages
If the system technician presses
HELP
after entering “test packet-control”, the
following message appears:
Enter [cabinet(1)]; carrier (A-B),
[’long’ or ’short’], [’repeat’ (1-100)
or ’clear’], [’schedule’]