Avaya Definity SI, Maintenance Manual, Page: 902 / 2968

Maintenance Object Repair Procedures
555-233-123 10-116 Issue 4 May 2002
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of tone detectors
present or some tone detectors may be out-of-service.
1. Resolve any TTR-LEV errors in the Error Log.
2. Resolve any TONE-PT errors in the Error Log.
3. If neither condition exists, retry the command at 1-minute
intervals no more than 5 times.
4. If the test continues to abort, escalate the problem.
1004 ABORT A valid call seized the port during the test and aborted the test.
1. Use the display port UUCSSpp command to determine
the station extension.
2. Use the status station extension command to determine
the service state of the port.
3. If the port is in use, wait until the port is idle before testing.
Retry the command at 1-minute intervals no more than 5
times.
4. If the test continues to abort, escalate the problem.
1005 ABORT This test was aborted due to a configuration problem. The test
is not applicable for this type of analog port. This error can be
ignored.
1018 ABORT Administration has disabled the test. The default for the
Test?
field on the station form is y. Determine why this field
has been set to n on this station (this may be due to the
ringing application Test #48, which can be disturbing to
customer or terminal equipment).
1. To enable the test for a particular station being tested,
enter change station extension.
2. Change the
Test?
field on the station form to y.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT System resources required to run test are not available. This
could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals no more than 5
times.
2. If the test continues to abort, escalate the problem.
Table 10-38. TEST #6 NPE Crosstalk Test — Continued
Error
Code Test
Result
Description/Recommendation
Continued on next page