Avaya Definity SI, Maintenance Manual, Page: 808 / 2968

Maintenance Object Repair Procedures
555-233-123 10-22 Issue 4 May 2002
Table 10-9. TEST #13 Voice and Control Channel Local Loop Test
Error
Code Test
Result Description/Recommendation
ABORT Internal System Error. Try (a).
1000 ABORT System resources required to run this test are not available. The
port may be in use.
1. Use the display port PCSSpp command to determine the
voice port extension of the port.
2. Use the status station command to determine the service
state of the port. If the service state indicates that the port is
in use, you must wait until the port is idle before retesting.
3. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
1001 ABORT System resources required for this test are not available. Try (a).
1002 ABORT The system could not allocate time slots for the test. The system
may be under heavy traffic conditions, or may have time slots
that are out-of-service due to TDM-BUS errors. Refer to
“TDM-BUS” to diagnose TDM-BUS errors.
1. If the system has no TDM-BUS errors, and is not handling
heavy traffic, retry the command at 1-minute intervals a
maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present, or some Tone Detectors may be out-of-service.
1. Resolve any “TTR-LEV” errors.
2. Resolve any “TONE-PT” errors.
3. If neither condition exists, try (a).
1004 ABORT The port was put in use during the test.
1. Use the display port PCSSpp to determine the voice port
extension of the port.
2. Use the status station command to determine the service
state of the port. If the service state indicates that the port is
in use, you must wait until the port is idle before retesting.
3. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
2000 ABORT Response to the test was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources for this test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Continued on next page