Avaya Definity SI, Maintenance Manual, Page: 2097 / 2968

PKT-INT (Packet Interface)
Issue 4 May 2002 10-1311 555-233-123
Table 10-486. TEST #886 Maintenance Looparound Test
Error
Code Test
Result Description/Recommendation
1006
1137 ABORT Packet Interface is in the out-of-service state so normal
maintenance tests will not run on it.
1. Reset the Packet Interface using the reset
packet-interface CS command. Refer to the Packet
Interface Reset Test (#889) maintenance documentation for
further action.
1139 ABORT The Packet Bus is alarmed
1. Try to retire the alarm associated with the Packet Bus. Refer
to the Alarm Log through the display alarms command.
Refer to the maintenance documentation for Packet Bus
Maintenance for further action.
2. Retry the command when the alarm associated with the
Packet Bus is retired.
1335 ABORT Internal system error. The Packet Interface is on the standby
SPE and this test is not allowed to execute on a Packet
Interface on the standby SPE.
1. If you wish to run this test on a standby Packet Interface,
you must first make it active with reset system
interchange. .
1338 ABORT The test is not allowed to run since a planned SPE interchange
is in progress. A planned interchange may be caused by 24
hour scheduled testing. During this time the terminal will be held
out of service but it should recover automatically after 3 minutes.
1. Wait 3 minutes and retry the command.
1373 ABORT Could not establish the link loop around link to run this test.
1. Retry the command at 1-minute intervals, a maximum of 3
times.
2060 ABORT Packet bus link went down during maintenance looparound test.
1. Retry the command at 1-minute intervals, a maximum of 5
times.
2. If there are errors associated with the Packet Bus, refer to
the maintenance information associated with the Packet
Bus.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals, a maximum of 5
times.
Continued on next page