Avaya Definity SI, Maintenance Manual, Page: 2896 / 2968

Error Messages from Chapter 8: Maintenance
Commands
555-233-123 A-92 Issue 4 May 2002
If the system technician presses
HELP
after entering “set vector” on a duplex
system, the following message appears:
Enter a memory dump vector value: (0-F),
[’spe-active’, ’spe-standby’, ’spe-maint’]
The memory dump vector value is a hex value representing restart levels
A hex value of ’1’ causes memory dumps to be taken on WARM restarts
A hex value of ’2’ causes memory dumps to be taken on COLDII restarts
A hex value of ’4’ causes memory dumps to be taken on COLDI restarts
A hex value of ’8’ causes memory dumps to be taken on REBOOT restarts
All other hex values represent a combination of restart levels.
The combination is determined by adding the hex values of the individual
restarts together (e.g. a hex value of ’3’ causes memory dumps to
be taken on WARM and COLDII restarts, a hex value of ’F’ causes memory
dumps to be taken on WARM, COLDII, COLDI, and REBOOT restarts, etc.)
Error Messages
If the format of the condition (dump vector value) is invalid, the following message
appears:
Entry invalid; please press
HELP
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then
resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
status access-endpoint
Help Messages
If the user presses
HELP
after entering “status access-endpoint,” the following
message appears:
Enter assigned extension, [’print’]