Avaya Definity SI, Maintenance Manual, Page: 1030 / 2968

Maintenance Object Repair Procedures
555-233-123 10-244 Issue 4 May 2002
ATM Board Reset (#1256)
This test is destructive.
This test checks the sanity of the angel processor using the Sanity and Control
Interface (SAKI) test (Common Port Board test #53). It resets the circuit pack if the
SAKI test fails and runs the test again.The ATM Board Reset test passes if SAKI
can successfully reset and retest the board.
Before running the SAKI test, you must:
■
Move synchronization off the ATM-TRK circuit pack
■
Busyout the ATM-TRK circuit pack
The test aborts if the ATM-TRK circuit pack is supplying synchronization.
Table 10-97. Packet Interface Loop Around Test (#598)
Error
Code Test
Result Description/Recommendation
1144 ABORT The packet bus in the PPN has a major alarm against it.
Run display alarms and display errors.
Perform the PKT-BUS repair procedures associated with the
alarms.
Retry the command.
2000 ABORT Test request timed out.
Retry the command up to 3 times at 1-minute intervals.
If the test fails repeatedly, run reset board UUCSS.
If the test continues to fail, replace the ATM-TRK circuit pack.
2012 ABORT Internal system error
2100 ABORT Could not allocate needed system resources.
Retry the command up to 5 times at 1-minute intervals.
ANY FAIL Data packet not received correctly by the ATM Interface circuit
pack.
Retry the command up to 5 times at 1-minute intervals.
If the test continues to fail, replace the ATM-TRK circuit pack.
PASS The Packet Interface Test passed.
Continued on next page