Avaya Definity SI, Maintenance Manual, Page: 1359 / 2968

DIG-LINE (Digital Line)
Issue 4 May 2002 10-573 555-233-123
Table 10-212. TEST #9 Digital Line NPE Crosstalk Test
Error
Code Test
Result Description/Recommendation
1 ABORT During testing of the primary information channel, system
resources may not have been available. Also, the port may
have been busy during the test.
1. Check the port status. Use the display port PCSSpp
command to determine the station extension of the port.
Use the status station command to determine the service
state of the port. If the service state indicates that the port
is in use, then the port is unavailable for this test. You will
have to wait until the port is idle.
2. If the port status is idle, then retry the command a
1-minute intervals a maximum of 5 times.
2 ABORT During testing of DTDM, system resources may not have been
available. Also, the port may have been busy during the test.
1. Check if port is being used. If possible, disconnect by
toggling disconnect button on DTDM. Retry command
after 1 minute.
!
WARNING:
This action will drop the call in progress.
2. If the test continues to abort after 5 attempts, escalate the
problem.
1000 ABORT System resources required to run this test are not available.
The port may be busy with a valid call. Use display port
PCSSpp to determine the station extension or attendant
number of the port. Use status station or status attendant to
determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable for
certain tests. You must wait until the port is idle before
retesting. Attendants are always in use (off-hook) if the
handset is plugged in and the port is not busied out.
1. If the port status is idle, then retry the command at
1-minute intervals a maximum of 5 times.
1001 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Continued on next page