Maintenance Object Repair Procedures
555-233-123
10-1620
Issue 4 May 2002
System Technician Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order they are presented in the table below when
inspecting errors in the system. By clearing error codes associated with the Tape
DMA Latch Test for example, you may also clear errors generated from other tests
in the testing sequence.
Notes:
a. The Tape Read/Write Test only runs in the following software releases;
■
G1
■
G3iV1, EDI 6.0 and earlier.
b. The Tape Block Error Test runs only in software release G3iV1, EDI 15.0
and earlier.
c. Refer to TAPE-DAT (Tape Consistency) Maintenance documentation for
the description of this test.
Tape Read/Write Test (#65)
The purpose of this test is to exercise the hardware read/write circuitry and the
basic functionality of the tape cartridge. This test is done by reading 22 blocks of
data and by then writing 22 blocks of data into reserved space on the tape
cartridge.
NOTE:
This test does not check for tape cartridge data consistency, nor does it
check the integrity of every block on tape.
Order of Investigation
Short Test
Sequence
Long Test
Sequence
D/
ND
1
1
D = Destructive; ND = Nondestructive
Tape Reset Test (#67)
X
ND
Tape DMA Latch Test (#230)
X
X
ND
Tape Diagnostic Test (#66)
X
X
ND
Tape Read/Write Test (#65) (a)
X
ND
Tape Block Error Test (#692) (b)
X
ND
Tape Status Test (#69)
X
X
ND
Tape Translation Status Test (#505)
X
ND
TAPE-DAT Tape Consistency Test (#421) (c)
X
ND
Summary of Contents for Definity SI
