Avaya Definity SI, Maintenance Manual, Page: 1521 / 2968

EMG-XFER
Issue 4 May 2002 10-735 555-233-123
Notes:
a. Refer to “DC-POWER” for a description of this test.
b. Refer to “EXT-DEV” for a description of this test.
c. Refer to “RING-GEN” for a description of this test.
NOTE:
These tests only show up in the test sequence if there is a TN768
Tone-Clock Board in the port network being tested.
Emergency Transfer Query Test (#124)
This test queries the hardware for the state of the Emergency Transfer switch (or
switches in a High or Critical Reliability system) and reports the result. If the
switch(es) is (are) in a position where the system software can control Emergency
Transfer, then the test passes. If the switch(es) is (are) in a position where the
system software cannot control Emergency Transfer, then the test fails. In the
PPN, the Maintenance/Tape Processor controls Emergency Transfer and, in the
EPN, the EPN Maintenance circuit pack controls Emergency Transfer. The
system software does not have control of Emergency Transfer within a cabinet if
the switch(es) is (are) in the manual ON or manual OFF state for that cabinet.
Table 10-275. TEST #124 Emergency Transfer Query Test
Error
Code Test
Result Description/Recommendation
1000 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2000 ABORT Response to the test request was not received within the
allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to ABORT with error code 2000, check
for system powering problems with the A carrier (PPN or
EPN). Resolve all DC-POWER alarms. Then, repeat the
test.
3. If the test continues to ABORT with a 2000 error code,
check for and resolve all DUPINT (Duplication Interface)
errors in a PPN for a high or critical reliability system, or
MAINT (EPN Maintenance circuit pack) errors in an EPN.
Repeat the test.
Continued on next page