ANN-BD (Announcement Circuit Pack)
Issue 4 May 2002
10-137
555-233-123
!
WARNING:
Announcement board alarms are upgraded to MAJOR when the BASE Tone
Generator is set to 12. (France).
Notes:
a. Error Type 1
The circuit pack totally stopped functioning or it was
physically removed from the system.
NOTE:
The alarm is logged about 11 minutes after the circuit pack has been
removed and/or SAKI Test (#53) fails.
If the circuit pack is not in the system, insert a circuit pack (in the same slot
as the error indicates) to resolve this error. Or, if the circuit pack is in the
system and the red LED is on, follow the instructions for “Red (alarm)” in
the “Control and Port Circuit Pack Status Led” section in Chapter 7, “LED
Interpretation”.
NOTE:
The alarm is logged about 11 minutes after the circuit pack has been
removed and/or SAKI Test (#53) fails.
2561
Super Frame
Match Inquiry
Test (#211)
MINOR
ON
test board PCSS sh r 3
17676
In-line Error
2817(l)
Announcement
Checksum Test
(#209)
MINOR
ON
test board PCSS sh r 3
17682
In-line Error
17699
(m)
In-line Error
3840(n)
Any
None
3999(o)
Any
None
1
Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
Table 10-44. Announcement Circuit Pack Error Log Entries — Continued
Error
Type
Aux
Data
Associated
Test
Alarm Level
(See WARNING
below)
On/
Off
Board
Test to Clear Value
Continued on next page
Summary of Contents for Definity SI
