Avaya Definity SI, Maintenance Manual, Page: 927 / 2968

ANN-BD (Announcement Circuit Pack)
Issue 4 May 2002 10-141 555-233-123
Angel-Speech Processor (SP) Handshake Test
(#208)
This test checks the integrity of the communication link between the two
processors on the Announcement circuit pack. Failure of this test indicates that
the Speech Processor is insane and results in the loss of all integrated
announcements on the circuit pack.
Table 10-46. TEST #208 Angel-Speech Processor (SP) Handshake Test
Error
Code Test
Result Description/Recommendation
2000 ABORT Response to the test request was not received within the
allowable time period. If Error Type 1538 is present in the Error
Log, follow the maintenance strategy recommended for this
Error Type.
2100 ABORT Could not allocate the necessary system resources to run this
test.
ABORT Internal System Error.
1. Retry the command at 1-minute intervals a maximum of 5
times.
FAIL Test failed. Circuit pack cannot be used. Announcement
speech memory is cleared when this test fails. Therefore,
when the problem has been resolved, announcements
must be rerecorded or downloaded to the circuit pack.
Refer to “General Notes” near the beginning of this
Maintenance documentation.
1. Reset the circuit pack via the reset board PCSS
command and then run this test again. If the test continues
to fail, replace the circuit pack and then run this test again.
2. If there are recurring alarms on this circuit pack caused by
this test failing, replace the circuit pack even if Step 1
works.
!
WARNING:
Replacing the circuit pack results in loss of integrated
announcements. See “General Notes” near the
beginning of this Maintenance documentation.
PASS The communications link between the two processors on the
Announcement circuit pack is functioning properly.
User-reported troubles on this circuit pack should be
investigated using other circuit pack and port tests. Refer to
“ANN-PT (Announcement Port)” Maintenance documentation
for a description of the port tests.
Continued on next page