Avaya Definity SI, Maintenance Manual, Page: 1099 / 2968

BRI-SET, ASAI-ADJ, BRI-DAT
Issue 4 May 2002 10-313 555-233-123
BRI XID Test (#628)
This test checks the D-channel connection between the SPE and the endpoint or
adjunct.
In this test, a D-channel XID frame is sent to the endpoint or adjunct over the
point-to-point signaling link. The test passes if the endpoint or adjunct responds
with a Layer 2 XID-RESPONSE frame.
This test must be administered to not run in the station administration form for
ports on a TN2208.
Table 10-124. TEST #628 BRI XID
Error
Code Test
Result Description/Recommendation
1000 ABORT The BRI-SET, ASAI-ADJ, ATT-ADJ, LGATE-AJ, ATTE-AJ is
busy. The test cannot be executed at this time:
1. Pause momentarily (30 seconds) and re-execute at this
time.
2. If this problem persists, escalate this problem.
NOTE:
A BRI-PORT can also be busy. When using this for
BRI-PORT/ABRI-PORT tests, the words “BRI-SET,
ASAI-ADJ, ATT-ADJ,“ can be changed to “BRI-PORT,
ABRI-PORT, ATT-ADJ.“
1005 ABORT The endpoint is not administered to support XID Testing.
1. If the endpoint documentation reflects support XID testing,
use the change station extension command to change
the XID Testing? field on the form to y.
1113 ABORT The signaling link between the switch and the endpoint is
down.
1. Use the test port PCSSpp long command to clear any
errors which prevent establishment of the signaling link.
2. Examine the results of the Signaling Link Status Test
(#626) which is run as part of this command. If this test
aborts or fails, follow the repair procedure for Test #626.
3. If the XID test continues to abort, escalate the problem.
1139 ABORT The Packet Bus in the port network is out-of-service.
1. Follow the repair procedures for the Packet Bus.
2. After completing Step 1, execute the test port long
PCSSpp command, and review the results of the BRI Port
Local LAN Loop Around Test to verify the repair.
Continued on next page