Avaya Definity SI, Maintenance Manual, Page: 915 / 2968

AN-LN-PT (Analog Line Port)
Issue 4 May 2002 10-129 555-233-123
Looparound Test (#161)
This test checks the on-board transmission capabilities of the NPE, the codec,
and the battery feed chip of the analog port. The test passes if the signal
measured by the tone detector is within acceptable limits.
Table 10-43. TEST #161 Looparound Test
Error
Code Test
Result
Description/Recommendation
ABORT Necessary system resources could not be allocated to run this
test.
1. Retry the command at 1-minute intervals no more than 5
times.
2. If the test continues to abort, escalate the problem.
1000 ABORT System resources are unavailable. The port may be busy with
a valid call. This result is also reported for the system’s
Music-On-Hold port when it is off-hook, which it usually is.
1. Enter display port UUCSSpp to determine the station’s
extension.
2. Enter status station extension to determine the service
state of the port.
3. If the port is in use, wait until the port is idle. Retry the
command at 1-minute intervals no more than 5 times.
4. If the test continues to abort, escalate the problem.
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or have time
slots out-of-service due to TDM-BUS errors.
1. Refer to “TDM-BUS” to diagnose any active TDM-BUS
errors.
2. If the system has no TDM-BUS errors and is not handling
heavy traffic, retry the command at 1-minute intervals no
more than 5 times.
3. If the test continues to abort, escalate the problem.
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of tone detectors
present or some tone detectors may be out-of-service.
1. Resolve any TTR-LEV errors in the Error Log.
2. Resolve any TONE-PT errors in the Error Log.
3. If neither condition exists, retry the command at 1-minute
intervals no more than 5 times.
4. If the test continues to abort, escalate the problem.
Continued on next page