Avaya Definity SI, Maintenance Manual, Page: 945 / 2968

ANN-PT (Announcement Port)
Issue 4 May 2002 10-159 555-233-123
Notes:
a. The Announcement circuit pack can exhibit a condition that does not allow
recording.
Table 10-52. TEST #205 Channel Administration Memory Array (CAMA) Test
Error
Code Test
Result Description/Recommendation
1000 ABORT System resources required to run this test are not available.
The port may be in use on a valid call.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort, and the circuit pack is not in
use, escalate the problem.
2000 ABORT Response to the test request was not received within the
allowable time period. See Note (a) at end of table for more
information.
2100 ABORT Could not allocate the necessary system resources to run this
test.
ABORT Internal System Error.
1. Retry the command at 1-minute intervals a maximum of 5
times.
FAIL Test failed. Announcements played back on this port may
sound corrupted.
1. Reset the circuit pack via the reset board PCSS
command and then run this test again. If the test
continues to fail, replace the circuit pack (see Warning).
2. If there are recurring alarms on this port caused by this
test failing, replace the circuit pack even if Step 1 works
(see Warning).
!
WARNING:
Replacing the circuit pack results in loss of integrated
announcements. Refer to “General Notes” near the
beginning of this Maintenance procedure.
PASS This test verifies that the Angel processor can properly set up
this port for playbacks. User-reported troubles on this circuit
pack should be investigated using other port and circuit pack
tests. (Refer to “ANN-BD (Announcement Circuit Pack)”
Maintenance documentation for a description of the circuit
pack tests.)
Continued on next page