Avaya Definity SI, Maintenance Manual, Page: 1478 / 2968

Maintenance Object Repair Procedures
555-233-123 10-692 Issue 4 May 2002
1314 FAIL The TN767E DS1 circuit pack could not deactivate the loopback
through the far-end CSU.
1. Make sure that the far-end DS1 is installed if the far-end
CSU is a 120A CSU Module/T1 Sync Splitter.
2. Retry the test ds1-loop UUCSS end-loopback/span-test
command at 1-minute intervals for a maximum of 5 times.
PASS The active long-duration loopback or span test on the TN767E
circuit pack was successfully terminated.
0 NO
BOARD The test could not relate the internal ID to the port (no board).
This could be due to incorrect translations, no board is inserted,
an incorrect board is inserted, or an insane board is inserted.
1. Check to ensure that the board translations are correct. Use
the add ds1 UUCSS command to administer the DS1
interface if it is not already administered.
2. If board was already administered correctly, check the error
log to determine if the board is hyperactive. If this is the
case, the board is shut down. Reseating the board will
re-initialize the board.
3. If the board was found to be correctly inserted in step 1,
issue the busyout board command.
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the link between the internal ID and the
port.
Table 10-251. TEST #1216 End Loopback/Span Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page