
DID-TRK (DID Trunk)
Issue 4 May 2002
10-541
555-233-123
To temporarily alleviate the alarm caused by the failure of this test, the test may be
disabled from trunk administration Test field. (This also disables the port
diagnostic test.
Table 10-198.
TEST #33 Loop Around and Conference Circuit Test
Error
Code
Test
Result
Description/Recommendation
ABORT
Could not allocate the necessary system resources to run this
test. This could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5
times.
3
ABORT
System resources required to run this test are not available.
The seized tone detector did not respond. This abort code is
usually associated with tone-clock (TONE-BD, TONE-PT, and
TDM-CLK) resources.
1. Clear any tone errors in the error log.
2. Retry the command a 1-minute intervals for a maximum of
5 times.
3. If the test continues to abort, escalate the problem.
1000
ABORT
System resources required to run this test are not available.
The port may be busy with a valid call. Use the display port
PCSSpp command to determine the station extension,
attendant number, or trunk group/member number of the port.
Use the status station, status attendant, or status trunk
command to determine the service state of the port. If the
service state indicates that the port is in use, then the port is
unavailable for certain tests. (Refer to the “Status Commands”
section in Chapter 10, “Maintenance Commands and
Trouble-Clearing Aids”, for a full description of all possible
states.) You must wait until the port is idle before retesting.
Attendants are always in use (off-hook) if the handset is
plugged in and the port is not busied out.
1. If the port status is active but the port is not in use (no
calls), check the Error Log for Error Type 513 (see Error
Log table for description of this error and required
actions). The port may be locked up.
2. If the port status is idle, then retry the command at
1-minute intervals a maximum of 5 times.
Continued on next page
Summary of Contents for Definity SI
