Avaya Definity SI, Maintenance Manual, Page: 2409 / 2968

TAPE (Tape Unit) [G3iV1.1-286]
Issue 4 May 2002 10-1623 555-233-123
Status Request Test (#69)
This test requests the Maintenance/Tape Processor (MTP) firmware on the TN773
Processor circuit pack for the current Tape Unit status and displays the results.
Tape DMA Latch Test (#230)
Also known as the Tape Interface Test, this test checks the shared RAM on the
TN770 Memory circuit pack. The test also checks the communication paths on the
TN773 Processor circuit pack.
Table 10-599. TEST #69 Status Request Test
Error
Code Test
Result Description/Recommendation
1029 to
2051 ABORT Refer to the STBY-SPE (Standby SPE) Maintenance
documentation for a description of these error codes.
9000’s ABORT Refer to Table A in ‘‘Tape Unit Aux Data/Error Codes Tables’’
and follow the recommended repair strategy for specific Aux
Data.
Any
Others FAIL Refer to Table B in ‘‘Tape Unit Aux Data/Error Codes Tables’’
and follow the recommended repair strategy for specific Aux
Data.
PASS This test verifies the basic communication between the
Processor and the Tape Drive circuit pack.
Continued on next page
Table 10-600. TEST #230 DMA Latch Test
Error
Code Test
Result Description/Recommendation
1029 to
2051 ABORT Refer to the STBY-SPE (Standby SPE) Maintenance
documentation for a description of these error codes.
23001 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
23002 to
23005 FAIL Hardware not responding.
1. Follow the instructions provided in the ‘‘Tape
Maintenance and Repair Procedures’’ section.
Continued on next page