Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 894 / 1930

Maintenance Objects
555-233-119
894
Issue 5 October 2002
1003 ABORT The system could not allocate a Tone-Clock circuit pack for the test
connection. This situation could occur when the system is heavily loaded or
if a Tone-Clock circuit pack is not present in the port network when this test
is executed.
1. Verify the existence of a Tone-Clock circuit pack in the same port
network.
2. If a Tone-Clock circuit pack is missing, install one in the same port
network.
3. Allow approximately 1 minute for the Tone-Clock circuit pack
maintenance to run on the newly inserted Tone-Clock circuit pack.
4. Retry the command at 1-minute intervals a maximum of 5 times.
2006 ABORT This abort code indicates that the active Tone-Clock circuit pack might not
be functioning properly. If there is more than one Tone Detector circuit pack
in the system, the problem can be either with the Tone-Clock circuit pack or
the Tone Detector circuit pack. This could also be caused by the
companding mode administered for the system not matching that of the
Tone Detector circuit pack.
1. Make sure that the companding mode of the system matches that of
the Tone Detector (TN748 for mu-law systems and TN420 for A-law
systems).
2. Test the active Tone-Clock circuit pack in the port network. This test is
being executed with test tone-clock qualifier system technician
command. (“qualifier” is the carrier of the active Tone-Clock circuit pack
to be tested. Valid qualifiers are: a, b, 1a, 1b, 2a, and 2b.) Refer to the
‘‘TONE-BD (Tone-Clock Circuit Pack)’’ Maintenance documentation for
details.
3. Retry the command at 1-minute intervals a maximum of 5 times.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1-3 FAIL DTMF digits were not detected correctly. This may or may not impact
reception of R2-MFC calls.
1. Run the short test sequence with test port PCSSpp sh r 1.
2. If the problem persists, the system is still operating properly but system
capacity will be reduced. In order to restore system performance to
normal, replace the Call Classifier circuit pack containing the defective
CLSFY-PT (Call Classifier Port).
Table 152. TEST #42 Tone Detection Verification Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page