Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1144 / 1930

555-233-119
1144
Issue 5 October 2002
Table 244. TEST #1227 ICSU Status LEDs Test
Error
Code Test
Result Description/ Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
1005 ABORT The ICSU Status LEDs test can not be executed for the current
configuration. The test applies only to TN767E or later DS1 circuit packs
administered for 24-channel operation (1.544 bit rate).
1. If the circuit pack is a TN767E or later suffix DS1 circuit pack, then retry
the command.
1951 ABORT The ICSU Status LEDs Test can not be executed because a 120A1 or later
suffix CSU Module or a 401A or later suffix T1 Sync Splitter is not physically
installed. If using a 120A1 CSU Module/T1 Sync Splitter, physically connect
it to the TN767E board on the back of the port carrier otherwise, ignore this
abort.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
2500 ABORT Internal system error.
1. Retry the command.
PASS The ICSU Status LEDs test executed successfully. A PASS result, however,
does not necessarily mean that the status LEDs behaved properly. It only
means that the software successfully attempted to light the status LEDs.
This is a visual test. The service technician must visually exam the behavior
of the LEDs while the test is running. The LEDs are functioning properly if
the four status LEDs are lit red for 5 seconds, then lit green for 5 seconds,
then lit yellow for 5 seconds. If the LEDs behave differently, escalate this
problem.
Continued on next page