Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1642 / 1930

Maintenance Objects
1642
Issue 5 October 2002
Layer 3 Query Test (#1243)
This test is nondestructive. This test is used to check the application layer
communications across the in-service ISDN D-Channel. The test passes if a
status enquiry message was successfully sent, fails if the signaling link is down,
and aborts if a query is already running or there is an internal error.
Table 479. TEST #1243 Layer 3 Query
Error
Code Test
Result Description/ Recommendation
1019 ABORT Test is already running.
1113 ABORT The signaling link is down.
1. Use the test port PCSSpp long command to clear any errors which
prevent establishment of the signaling link.
2. Examine the results of Test #626, which is executed with the
command. If this test aborts or fails, follow the repair procedure for the
Signaling Link Status Test.
1141 ABORT The PKT-INT is out-of-service.
1. Consult the repair procedure for PKT-INT.
1187 ABORT The circuit pack or port may have been busied out by a technician.
1. Look in the Error Log for Error Type 18 (busied out) for TBRI-BD or
TBRI-PT.
a. If this error type is present for TBRI-PT, then release the port with
the release port PCSSpp command, and run the test again.
b. If the error is present for both TBRI-BD and TBRI-PT, then release
the circuit pack with the release board PPCSS command and run
the test again.
NOTE:
When you release the circuit pack, you release all ports associated
with it. If certain ports still need to be busied out, use the release
port PCSSpp command to busy them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals a maximum of 5 times.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
PASS The switch has successfully sent a Status Enquiry message.
Continued on next page