Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1226 / 1930

555-233-119
1226
Issue 5 October 2002
Table 279. TEST #1386 CLAN Ethernet Status Test
Error
Code
Test
Result Description/ Recommendation
1125 ABORT Ethernet Link is not in service.
1. Check if the ethernet link is in-service or not. If the link is not in
service, release the link using release link n or the release port
UUCSSpp command and repeat the test. This is a normal abort.
2. If the test continues to abort after following the repair procedures,
escalate the problem.
2000 ABORT Response to the test was not received from the CLAN TN799 circuit
pack within the allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit pack if
the other ports on the board are not in use (Yellow LED is off).
Reset the circuit pack by issuing the busyout board UUCSS,
reset board UUCSS, and release board UUCSS commands.
2. If this result occurs again, replace the circuit pack.
2100 ABORT The necessary system resources to execute the test could not be
allocated.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 3 times
FAIL The CLAN ethernet port corresponding to the near-end address of the
SIG-GRP that is OOS has failed. All sessions are down.
1. Execute test port UUCSSpp long and verify the result of the
H.323 Signaling Group Ping Test (#1387). If the test continues to
fail, escalate the problem. If the test passes wait for the sessions
to come up.
PASS The CLAN ethernet port corresponding to the near-end address of the
SIG-GRP that is in-service has passed this test. All sessions on the
ethernet link are up.
Continued on next page