Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1473 / 1930

PKT-INT (Packet Interface)
Issue 5 October 2002
1473
555-233-119
Table 391. TEST #884 Memory Checksum Test
Error
Code Test
Result Description/ Recommendation
1006
1137 ABORT Packet Interface is in the out-of-service state so normal maintenance tests will
not run.
1. Use the display system-parameters maintenance command to
identify which C-LAN circuit pack is administered with the Bus
Bridge. Verify that the C-LAN circuit pack is present and is not
alarmed.
2. Request a Packet Interface reset using the reset
packet-interface AS command. Refer to the Packet Interface
Reset Test (#889) repair procedures for further action.
1334 ABORT The Packet Interface command queue is full. This should be a temporary
condition caused by a high rate of commands being sent to a Packet
Interface. Continued operation with a full command queue will cause a system
WARM restart that may escalate to more severe restart levels.
1. Retry the command at 10-second intervals, a maximum of 5
times.
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals, a maximum of 3 times.
2500 ABORT Internal system error.
1. Retry the command.
NO
BOARD The Packet Interface is not detected as being physically present.
1. Reboot the system, then retry the command. If the NO BOARD
indication persists, replace the TN2402/TN798 Processor circuit
pack.
1537 FAIL The Boot PROM memory checksum test failed. The Packet Interface may still
be operational.
1. Retry the command.
2. If the same error code occurs, replace the TN2402/TN798
Processor circuit pack at a time that would cause the least
disruption of service. The Packet Interface is still functional but
should be replaced since it may not operate after a system reboot
and it will enter a fatal fault state if it is reset for other reasons.
Continued on next page