Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1461 / 1930

PKT-BUS (Packet Bus)
Issue 5 October 2002
1461
555-233-119
Packet Circuit Pack Audit Test (#573)
This test determines whether Packet circuit packs have reported Packet
Bus-related in-line errors within the last minute. If so, the failure code indicates
whether one or more circuit packs have reported failures within the last minute.
Due to the one-minute time constraint included as part of this test, the test is
designed to delay 15 seconds before returning a result in cases where the test
has failed within the last five minutes. This procedure helps ensure that a
repeated sequence of the test does not always yield the same result. If no failure
has occurred in the last five minutes, a PASS is returned immediately.
Table 389. Test #573 Packet Circuit Pack Audit Test
Error
Code Test
Result Description/ Recommendation
2500 ABORT An internal operation failed; the test could not be completed.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1 FAIL One Packet circuit pack has reported Packet Bus-related in-line errors within the
last minute.
2 FAIL More than one Packet circuit pack has reported Packet Bus-related in-line errors
within that last minute.
1. Refer to the "Packet Bus Fault Isolation Flowchart" section in Chapter 9 to
determine the cause of the error reports.
PASS No Packet circuit packs have reported Packet Bus-related in-line errors within
the last minute. This indicates that the Packet Bus is healthy, or that a Packet
Bus fault is transient or is being caused by a faulty Packet circuit pack. If this test
passes while there are other signs of a Packet Bus failure (as indicated, for
example, in the Error/Alarm Logs or by other test failures), refer to the "Packet
Bus Fault Isolation Flowchart" section in Chapter 9 to isolate the problem.
Continued on next page