Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1694 / 1930

Maintenance Objects
1694
Issue 5 October 2002
TIE-TRK (Tie Trunk)
NOTE:
If ATMS testing is enabled, check the error log for ATMS Errors #3840 and
#3841. If the error log indicates that measurements exceeded acceptable
thresholds, and if no other trouble is found with the test trunk command,
run the ATMS test call with the test analog-testcall port PCSSpp full
command.
The following circuit packs are covered by this section of TIE-TRK (Tie Trunk):
■
TN497
■
TN2140B
The Tie Trunk circuit pack fits into a port slot and contains four trunk circuits (see
Figure 53 on page 1695 ). Each tie trunk for the TN497 circuit packs has 2-wire
audio connection/signal leads (A and B).
A tie trunk port can also be administered as an access endpoint, which is a
non-signaling channel with a voice-grade data bandwidth.
MO Name (in
Alarm Log) Alarm Level Initial Command to Run
1
1. Where P is the port network number (1); C is the carrier designation (for example, A, B,
or C); SS is the address of the slot in the carrier where the circuit pack is located (for
example, 01, 02, etc.); and pp is the 2-digit port number (for example, 01).
Full Name of MO
TIE-TRK
2
2. Not relevant to the TN497 circuit pack.
MAJOR
3
3. A Major alarm on a trunk indicates that alarms on these trunks are not downgraded by
the set options command and that at least 75 percent of the trunks in this trunk group
are alarmed. (This is not relevant to the TN497 circuit pack.)
test port PCSSpp l Tie Trunk
TIE-TRK MINOR test port PCSSpp l Tie Trunk
TIE-TRK WARNING test port PCSSpp sh Tie Trunk