Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1156 / 1930

555-233-119
1156
Issue 5 October 2002
1001 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system is under
heavy traffic conditions or has time slots out-of-service due to TDM-BUS
errors. Refer to TDM-BUS to diagnose any active TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic,
repeat test at 1-minute intervals a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system is
oversized for the number of Tone Detectors present, or some Tone
Detectors are out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer to TTR
documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer to TONE-PT
documentation.
3. If neither condition exists, retry the command at 1-minute intervals a
maximum of 5 times.
1004 ABORT The port was seized by a valid call during the test.
1. Use display port PCSSpp to determine the station extension or
attendant number of the port.
2. Use status station or status attendant to determine the service state
of the port. If the service state indicates that the port is in use, then the
port is unavailable for certain tests.
3. Wait until the port is idle before retesting. Attendants are always in use
(off-hook) if the handset is plugged in and the port is not busied out.
1020 ABORT Test disabled by background testing. Use the status station command to
determine when the station is available for testing.
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1
2 FAIL The Network Processing Element (NPE) of the tested port is transmitting in
error. This causes noisy and unreliable connections.
Failure code 1 indicates that the Crosstalk test failed on the primary channel.
Failure code 2 indicates that the Crosstalk test failed on the secondary
channel.
1. Replace the circuit pack.
Table 249. TEST #9 Digital Line NPE Crosstalk Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page