Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1293 / 1930

ISDN-SGR (ISDN-PRI Signaling Group)
Issue 5 October 2002
1293
555-233-119
h. These error codes are used to report certain error messages received by
the ISDN-PRI Signaling Group for one of its associated B-channels. The
aux data field shows for which B-channel (port number) the message was
received.
The error code generated equals 3840+x, where x is a Cause Value
defined by the ISDN PRI Specification. Note that there is no Test to Clear
Value for these error types; selected ISDN cause values are placed in the
log when they are received, but no direct action or alarming is performed
solely in response to receiving them. They provide added data that may
prove useful when tracking down obscure networking and routing
problems.
Table 309 provides more information:
Table 309. Descriptions of Error Codes 3842-3942
Error
Code
Description Recommendation
3842 A request has been made
to use a transit network or
common carrier that cannot
be accessed. 1. From the circuit pack and port number (in the Aux
Data field), determine the trunk group against which
the error was reported.
2. Check all routing patterns containing this trunk group
for validity of interexchange carriers requested (IXC
field).
3843 No route to destination.
Request received to route
call through a transit
network that is recognized
but not allowed to carry the
call or not able to serve the
destination.
3846 The far-end switch has
indicated that the B-channel
(trunk) is not acceptable for
use in the call for which it
was requested. This could indicate an administration problem (for
example, the local switch and the far-end switch have
different B-channels administered), or could reflect the
occurrence of a normal race condition (for example, the
local switch has requested use of a B-channel which the
far-end switch had just reserved for use on another call).
1. From the circuit pack and port number (in the Aux
Data field), determine the trunk group against which
the error was reported.
2. Issue the status trunk command for the indicated
trunk.
3. Refer to the “DS1 ISDN Trunk Service States” and
“ISDN-PRI Trunk Service States” sections of
ISDN-TRK for recovery suggestions.
Continued on next page