Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1635 / 1930

TBRI-PT (TN2185 ISDN Trunk-Side BRI Port)
Issue 5 October 2002
1635
555-233-119
This Looparound Test runs the following individual tests on the two B-channels
(B1 and B2) associated with the port:
■
A Looparound Test across the TDM Bus for B1.
■
A Conference Circuit Test for B1.
■
A Looparound Test across the TDM Bus for B2.
■
A Conference Circuit Test for B2.
The tests are run in the above order. If one fails, the remaining tests in the
sequence are not executed, and the maintenance software returns an error code.
Table 475. TEST #619 BRI Port Local TDM Loop Around
Error
Code Test
Result Description/ Recommendation
1000 ABORT The system resources required to run this test are not available. The port
may be busy with a valid call. Use the display port PCSSpp command to
determine the trunk group/member number of the port. Use the status
bri-port PCSSpp command to determine the service state of the port. If the
service state indicates that the port is in use, then the port is unavailable for
certain tests. Wait until the port is idle before retesting.
1. If the port is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors. Refer to TDM-BUS to diagnose any active TDM Bus
errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
repeat test at 1-minute intervals a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test.
1. Look for TTR-LEV errors in the Error Log and if present, refer to
TTR-LEV.
2. Look for TONE-PT errors in the Error Log and if present, refer to
TONE-PT.
3. If neither condition exists, retry the test at 1-minute intervals a
maximum of 5 times.
1004 ABORT The port has been seized by a user for a valid call. Use the status trunk
command for the trunks associated with this port and determine when the
port is available for testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page