Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 643 / 1930

ANL-24-L (24-Port Analog Line)
Issue 5 October 2002
643
555-233-119
1000 ABORT System resources required to run test are not available. The port may be
busy with a valid call. This result is also reported for the system’s
Music-On-Hold port when it is off-hook, which it usually is.
1. Use display port PCSSpp to determine the station’s extension.
2. Use status station extension to determine the service state of the
port.
3. If the port is in use, wait until the port is idle. Retry the command at
1-minute intervals a maximum of 5 times.
1001 ABORT System resources required to run test are not available. This could be due
to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or have time slots out-of-service due to
TDM-BUS errors. Refer to “TDM-BUS” to diagnose any active TDM-BUS
errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic,
retry the command at 1-minute intervals a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of tone detectors present or some tone
detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer to
“TTR-LEV”.
2. Look for TONE-PT errors in the Error Log. If present, refer to
“TONE-PT”.
3. Retry the command at 1-minute intervals a maximum of 5 times.
1004 ABORT The port was by a valid call during the test. The test has been aborted. Use
the display port PCSSpp to determine the station extension. Use status
station to determine the service state of the port. If the port is in use, wait
until the port is idle before testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1018 ABORT The test has been disabled via administration. The default for the
Test
field on the Station screen is y. Determine why this field has been set to
n
for this station. It may be due to application Test #48, which can disturb
users or terminal operations.
1. To enable the test for the station being tested, enter change station
extension and set the Test field to y.
Table 38. TEST #6 NPE Crosstalk Test — Continued
Error
Code Test
Result
Description/Recommendation
Continued on next page