Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1593 / 1930

SW-CTL (Switch Control)
Issue 5 October 2002
1593
555-233-119
Switch Control Reset Test (#93)
This test is destructive.
This test resets the Switch Control and determines if it can successfully go
through its initialization sequence. The test is destructive since there is the
possibility of losing some control messages to or from port circuit packs.
Table 457. TEST #93 Switch Control Reset Test
Error
Code Test
Result Description/ Recommendation
2012 ABORT Internal system error
2013
2100
none ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2000 or
None FAIL The Switch Control could not be successfully reset. If this is a standard
system, the customer probably cannot make or receive calls.
1. This failure could be due to either a Processor circuit pack failure or the
loss of system timing signals. If the Switch Control is alarmed, then
suspect a Processor circuit pack failure. If the Switch Control is not
alarmed, investigate the possible loss of system timing signals. See
“TDM Bus Clock”. If many port circuit pack LEDs are lit, suspect a TDM
Bus Clock problem. If only the Processor circuit pack LED is lit, suspect
the Processor circuit pack. If the Processor circuit pack is determined to
be at fault, proceed to Step 2.
2. If calls cannot be made, replace the Processor board.
PASS The Switch Control has initialized correctly. Look at results of the other tests
to see if it is operating correctly.
Continued on next page