Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 617 / 1930

ADX8D-PT (AUDIX Digital Port)
Issue 5 October 2002
617
555-233-119
1000 ABORT System resources required to run this test are not available. The port may be
in use.
1. Use display port PCSSpp to determine the voice port extension of the
port. Use status station to determine the service state of the port. If the
service state indicates that the port is in use, wait until the port is idle
before retesting.
2. When the port is idle, retry the command at 1-minute intervals a
maximum of 5 times.
1001 ABORT System resources required to run this test are not available
1. Retry the command at 1-minute intervals a maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service due to
TDM-BUS errors. Refer to “TDM-BUS” to diagnose any active TDM-BUS
errors.
1. If system has no TDM-BUS errors, and if it is not handling heavy traffic,
retry the command at 1-minute intervals a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present, or some Tone
Detectors may be out-of-service.
1. Resolve any “TTR-LEV” errors.
2. Resolve any “TONE-PT” errors. Retry the command at 1-minute
intervals a maximum of 5 times.
1004 ABORT The port was put in use during the test. The test has been aborted. Use
display port PCSSpp to determine the voice port extension of the port. Use
status station to determine the service state of the port. If the port is in use,
wait until the port is idle before testing.
1020 ABORT Test disabled by background testing. Use status station to determine when
the voice port is available for testing.
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1
2 FAIL The NPE of the tested port is transmitting in error. This causes noisy and
unreliable connections. Failure code 1 indicates that the Crosstalk test failed
on the primary channel. Failure code 2 indicates that the Crosstalk test failed
on the secondary channel.
1. Replace the circuit pack.
Table 30. TEST #9 NPE Crosstalk Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page