Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 834 / 1930

Maintenance Objects
555-233-119
834
Issue 5 October 2002
Table 126. TEST #627 BRI Remote Loop Back
Error
Code Test
Result Description/ Recommendation
1000 ABORT Could not seize the endpoint or B-channels for test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1005 ABORT The endpoint’s MIMs Supported field is administered to “no.”
1. Use change station extension to change parameter only if the
endpoint documentation reflects support for ISDN-BRI Management
and Maintenance Procedures.
1113 ABORT The signaling link between the switch and the endpoint is down.
1. Use test port PCSSpp long to clear any errors which prevent
establishment of the signaling link.
2. Examine the results of the Signaling Link Status Test (#626) which is
run as part of this command. If this test aborts or fails, follow the repair
procedure for Test #626.
3. If the XID Test continues to abort, escalate the problem.
1139 ABORT The Packet Bus in the port network is out-of-service.
1. Follow the repair procedures for the Packet Bus.
2. After completing Step 1, use the port long PCSSpp and review the
results of the BRI Port Local LAN Loop Around Test to verify the repair.
1141 ABORT The PKT-CTRL is out-of-service.
1. Refer to PKT-CTRL (Packet Control Circuit Pack) Maintenance
documentation.
1144 ABORT The PPN Packet Bus is out-of-service.
1. Follow the repair procedures for the Packet Bus in the PPN.
2. After completing Step 1, use test port long PCSSpp, and review the
results of the BRI Port Local LAN Loop Around Test to verify the repair.
Continued on next page